345 Hemi Engine Bay Cup Holder Inlay

Complete Your Custom Badge Installation

The Rebadge Design & Graphics 345 Hemi Engine Bay Cup Holder Inlay, part number RBD345HEBCHI, adds a clean custom detail with a vehicle focused design. Indulge in our 2-piece 345 Hemi Engine Bay Cup Holder Inlay set.

Key Features

• Designed by Rebadge Design & Graphics for a precise custom appearance
• Purpose built accessory for a clean finished installation
• Made for straightforward installation with careful surface preparation
• Available through Black Ops Auto Works with fitment details listed below

Fitment

This accessory is not assigned to one vehicle platform. Confirm dimensions and mounting requirements before installation.

Specifications

What’s Included

• One selected 345 Hemi Engine Bay Cup Holder Inlay
• Application ready mounting components when supplied by the manufacturer

About Rebadge Design & Graphics

Rebadge Design & Graphics develops custom automotive badges, inlays, and appearance components for enthusiasts who want a distinctive factory inspired finish.

Related Parts

• 392 Engine Bay Cup Holder Inlay
• Hellcat Engine Bay Cup Holder Inlay
• Mopar Engine Bay Cup Holder Inlay

FAQ

What is the RBD345HEBCHI?

This product is the Rebadge Design & Graphics 345 Hemi Engine Bay Cup Holder Inlay, an accessory intended to support a clean custom installation.

Is this product vehicle specific?

No exact vehicle fitment is assigned. Verify the mounting area and dimensions for the intended application.

What is included?

The package includes the selected Rebadge component. Only items specifically shown or listed are included.

How is this product installed?

Confirm the mounting location, clean the area, test fit the component, and secure it using the intended mounting method.

Does installation require special tools?

Tool requirements depend on the mounting location. Basic cleaning supplies and common hand tools may be needed.

Can this accessory be removed?

Removal is generally possible, but the method depends on the mounting hardware or adhesive used.

Should the mounting surface be prepared?

Yes. The area should be clean, dry, and free of wax, oil, and debris.

How do I confirm compatibility?

Compare the product dimensions, mounting points, and intended use with the planned installation area before ordering.

Install Instructions

1. Verify the product and application against the fitment and specifications on this page.
2. Clean the mounting area and remove wax, grease, dust, and moisture.
3. Test fit the component and confirm the final position before securing the component.
4. Install using the supplied or intended adhesive or mounting hardware.
5. Apply even pressure, confirm alignment, and allow adhesive to bond before exposing the area to moisture.