aFe 11-23 Ford V6 3.5L High-Performance Ignition Coil – Single

This aFe ignition component is the 11-23 Ford V6 3.5L High-Performance Ignition Coil – Single for 2015-2017 Ford Expedition. Match the exact engine, connector, coil location, electrical requirements, quantity, and calibration needs before ordering.

Key Features

• Higher output voltage versus OEM coil for a hotter, more complete spark.
• Direct OEM connector fit, no wiring modification required.

Fitment

Specifications

What’s Included

One new aFe stock replacement ignition in the exact configuration and quantity identified by this listing. Hardware, clamps, couplers, gaskets, sensors, wiring, fluids, calibration, and accessories are included only when expressly stated.

About aFe Power

aFe Power develops application-specific intake, filtration, exhaust, cooling, tuning, suspension, drivetrain, and truck-performance components supported by product testing and documented installation requirements.

Important Disclosures

• California Proposition 65 warning: this product can expose you to chemicals known to the State of California to cause cancer and reproductive harm.

Related Parts

• aFe 03-12 Toyota 4Runner V6 4.0L / 05-23 Toyota Tacoma L4 2.7L SCORCHER Ignition Coil
• aFe 08-13 BMW 128i / 03-05 BMW 325i Scorcher High-Performance Ignition Coil
• Shop the complete aFe Power collection

Frequently Asked Questions

How many 11-23 Ford V6 3.5L High-Performance Ignition Coil – Single components are included (aFe 77-92010)?
Quantity is exactly what the listing states. Confirm whether the application requires one component or a complete engine set.

Will these work with the factory calibration?
Use only the ignition component specified for the exact engine and connector. Modified boost, fuel, plugs, or calibration can change ignition requirements.

Should spark plugs be serviced at the same time?
Inspect plug type, gap, condition, and service interval while access is available, following the engine and calibration requirements.

What should be checked if a misfire remains?
Verify connector seating, coil location, plugs, wiring, grounds, compression, fueling, and diagnostic codes instead of assuming the new component is the cause.

Installation Instructions

1. Confirm aFe part number 77-92010, the complete vehicle or specification-based application, and all required supporting components.
2. Disconnect power as directed, allow the engine to cool, and label connectors or coil positions before removal.
3. Inspect plugs and wiring, install components without damaging boots or terminals, and torque fasteners to the vehicle specification.
4. Verify smooth operation and check diagnostic data before returning the vehicle to service.