aFe 22-23 Toyota Tundra V6 3.4L (tt) Sway-A-Way 2.5in Front Coilover Kit

This aFe suspension component is the 22-23 Toyota Tundra V6 3.4L (tt) Sway-A-Way 2.5in Front Coilover Kit for 2022-2023 Toyota Tundra. Verify drivetrain, trim, ride-height range, bar or spring rate, mounting points, wheel and tire clearance, alignment needs, and intended street or off-road use.

Key Features

• Material: aircraft-grade aluminum construction for strength and corrosion resistance.
• Direct bolt-on using factory mounting points, no chassis modification required.
• Precision-machined for consistent, repeatable fitment.
• aFe Control coilover kit (101-5600-20).
• Schedule a four-wheel alignment at a qualified shop before regular driving.

Fitment

Specifications

What’s Included

One new aFe coilover in the exact configuration and quantity identified by this listing. Hardware, clamps, couplers, gaskets, sensors, wiring, fluids, calibration, and accessories are included only when expressly stated.

About aFe Power

aFe Power develops application-specific intake, filtration, exhaust, cooling, tuning, suspension, drivetrain, and truck-performance components supported by product testing and documented installation requirements.

Important Disclosures

• California Proposition 65 warning: this product can expose you to chemicals known to the State of California to cause cancer and reproductive harm.

Related Parts

• aFe Sway-A-Way 2.5in Front Coil Over Kit 10-14 Ford F-150 Raptor
• aFe Control PFADT Series Featherlight Single Adj Street/Track Coilover System 97-13 Chevy Corvette
• Shop the complete aFe Power collection

Frequently Asked Questions

Will the 22-23 Toyota Tundra V6 3.4L (tt) Sway-A-Way 2.5in Front Coilover Kit fit my suspension configuration (aFe 101-5600-20)?
Match drivetrain, trim, factory suspension, ride height, wheel and tire package, and any exclusions shown for this exact product.

Will an alignment be required?
An alignment is recommended whenever ride height or suspension geometry changes and may also be needed after replacing bars, arms, links, or mounts.

Does the kit change ride quality?
Ride and handling depend on rates, adjustment, bushings, tire setup, and installation. Use the settings recommended for the intended street or off-road use.

Should fasteners be rechecked after installation?
Yes. Torque fasteners at the specified suspension position, inspect clearance, and recheck hardware after the initial driving cycle.

Installation Instructions

1. Confirm aFe part number 101-5600-20, the complete vehicle or specification-based application, and all required supporting components.
2. Support the vehicle at approved points, record ride height and alignment condition, and compare every mount and component before disassembly.
3. Install hardware in the documented orientation and torque sequence, tightening pivot bushings at the specified ride position where required.
4. Verify full steering and suspension travel, wheel and tire clearance, alignment, and fastener torque before normal driving.