aFe Control 05-23 Toyota Tacoma Upper Control Arms – Red Anodized Billet Aluminum

This aFe suspension component is the Control 05-23 Toyota Tacoma Upper Control Arms – Red Anodized Billet Aluminum for 2023 Toyota Sequoia. Verify drivetrain, trim, ride-height range, bar or spring rate, mounting points, wheel and tire clearance, alignment needs, and intended street or off-road use.

Key Features

• Material: billet aluminum construction for strength and corrosion resistance.
• Finish: red anodized for long-term durability.
• Direct bolt-on using factory mounting points, no chassis modification required.
• Precision-machined for consistent, repeatable fitment.
• aFe Control upper control arm kit (460-72T005-R).
• Schedule a four-wheel alignment at a qualified shop before regular driving.

Fitment

Specifications

What’s Included

One new aFe control arm in the exact configuration and quantity identified by this listing. Hardware, clamps, couplers, gaskets, sensors, wiring, fluids, calibration, and accessories are included only when expressly stated.

About aFe Power

aFe Power develops application-specific intake, filtration, exhaust, cooling, tuning, suspension, drivetrain, and truck-performance components supported by product testing and documented installation requirements.

Important Disclosures

• California Proposition 65 warning: this product can expose you to chemicals known to the State of California to cause cancer and reproductive harm.

Related Parts

• aFe Silver Bullet Throttle Body Spacer 10-14 Chevrolet Camaro V6 3.6L
• aFe Silver Bullet Throttle Body Spacers 15-16 Ford Mustang GT V8-5.0L
• Shop the complete aFe Power collection

Frequently Asked Questions

Will the Control 05-23 Toyota Tacoma Upper Control Arms – Red Anodized Billet Aluminum fit my suspension configuration (aFe 460-72T005-R)?
Match drivetrain, trim, factory suspension, ride height, wheel and tire package, and any exclusions shown for this exact product.

Will an alignment be required?
An alignment is recommended whenever ride height or suspension geometry changes and may also be needed after replacing bars, arms, links, or mounts.

Does the kit change ride quality?
Ride and handling depend on rates, adjustment, bushings, tire setup, and installation. Use the settings recommended for the intended street or off-road use.

Should fasteners be rechecked after installation?
Yes. Torque fasteners at the specified suspension position, inspect clearance, and recheck hardware after the initial driving cycle.

Installation Instructions

1. Confirm aFe part number 460-72T005-R, the complete vehicle or specification-based application, and all required supporting components.
2. Support the vehicle at approved points, record ride height and alignment condition, and compare every mount and component before disassembly.
3. Install hardware in the documented orientation and torque sequence, tightening pivot bushings at the specified ride position where required.
4. Verify full steering and suspension travel, wheel and tire clearance, alignment, and fastener torque before normal driving.