aFe CONTROL 3-Inch Leveling Kit for 2025-2027 Ram 1500 RHO

Three inches of front lift without replacing the factory dampers

aFe CONTROL 416-20T003-R raises the front of the 2025-2027 Ram 1500 RHO up to three inches using billet spacers and includes sensor-relocation brackets for the factory ride-height system.

Key Features

• aFe 416-20T003-R: Up to three inches of front lift
• Billet aluminum shim and preload spacers
• Retains factory dampers
• 304 stainless-steel ride-height sensor relocation brackets
• Vehicle-specific hardware
• Red anodized finish

Fitment

Use aFe 416-20T003-R only for the applications below. Confirm every listed qualifier and exclusion.

Specifications

What’s Included

• Billet shim spacers for aFe 416-20T003-R
• Billet preload spacers
• Ride-height sensor relocation brackets
• Vehicle-specific installation hardware
• Not included: Replacement dampers
• Not included: Rear lift components
• Not included: Spring compressor
• Not included: Alignment service

About aFe

aFe CONTROL develops chassis and suspension components using vehicle-specific measurements, engineered materials, and installation hardware intended to preserve predictable street manners.

Related Parts

• A spring compressor and post-installation alignment are required; inspect the factory struts and front suspension hardware before disassembly.

FAQ

What is the 416-20T003-R?

It is an aFe CONTROL front leveling kit that uses billet spacers and sensor-relocation brackets.

What does this part fit?

It fits the listed 2025-2027 Ram 1500 RHO with the 3.0L twin-turbo inline-six.

What is it made from?

The spacers are billet aluminum and the sensor brackets are 304 stainless steel.

What comes in the box?

Front shim and preload spacers, sensor brackets, and installation hardware are included.

Is professional installation recommended?

Professional installation is recommended because the struts must be removed and the springs compressed.

Does installation require other parts?

A spring compressor, rear lift parts, replacement dampers, and alignment service are separate.

How should fitment be checked before ordering?

Compare every listed year, model, position, dimension, drivetrain, engine, and configuration qualifier with the vehicle or mounting interface.

What warranty applies?

Use aFe’s current limited warranty terms.

Installation Instructions

1. Confirm the vehicle is a 2025-2027 Ram 1500 RHO with the 3.0L twin-turbo engine.
2. Support the vehicle safely and remove the front strut assemblies following current Ram procedures.
3. Use a suitable spring compressor to install the shim and preload spacers, then fit the supplied ride-height sensor brackets.
4. Reassemble both sides, torque all hardware to specification, verify sensor and suspension clearance, and complete a professional alignment.

California Proposition 65 Warning: Cancer and Reproductive Harm – www.P65Warnings.ca.gov