Air Lift 160 PSI Air Shock Controller

This Air Lift pressure or height-management component is the 160 PSI Air Shock Controller for 2015 Ram ProMaster City. Confirm the supported air-spring system, number of paths or corners, pressure range, compressor and tank requirements, sensors, harness, controller functions, mobile-device compatibility, and included components.

Key Features

• This 160 PSI air shock controller allows driver controlled air shock pressure right from the driver’s seat.
• The kit includes a universal connector for most air shocks including factory installed, a rugged on board air compressor, and a dash mount gauge panel, hardware, and air lines.

Fitment

Specifications

What’s Included

One new Air Lift suspension controller in the exact configuration and quantity identified by this listing. Compressors, tanks, management, brackets, fittings, lines, wiring, sensors, tools, and additional hardware are included only when expressly stated for this part number.

About Air Lift

Air Lift develops vehicle-specific load-support air springs, adjustable performance suspension, compressors, and air-management systems. Exact fitment, pressure limits, travel, and system requirements vary by part number and application.

Important Disclosures

California Proposition 65 warning: this product can expose you to chemicals known to the State of California to cause cancer and reproductive harm.

Related Parts

• Air Lift Wireless One (2nd Generation)
• Air Lift Wireless One (2nd Generation) w/EZ Mount
• Shop the complete Air Lift collection

Frequently Asked Questions

Is Air Lift 25804, the 160 PSI Air Shock Controller, a pressure-based or height-based system?
Use the exact product specifications. Pressure and height sensing use different hardware and setup procedures, and some systems support one method while others support both.

What compressor and tank are required?
Size them for the controller, number of corners, pressure range, expected adjustment speed, duty cycle, and line size. Confirm every component in the current Air Lift system diagram.

Will the controller work with my phone?
Mobile support depends on the exact controller, supported operating system, wireless hardware, and current app requirements. Verify those details for this part number.

What should be calibrated after installation?
Complete the manufacturer’s leak test, sensor orientation checks, pressure or height calibration, preset setup, and safe driving-height verification before road use.

Installation Instructions

1. Confirm Air Lift part number 25804, the complete application, and every required supporting component before disassembly.
2. Disconnect the battery and plan protected compressor, tank, manifold, controller, sensor, air-line, and harness locations before mounting.
3. Install the specified fuse, relay, wire gauge, grounds, fittings, pressure protection, and ventilation using the current Air Lift diagram.
4. Check polarity, continuity, voltage drop, leaks, pressure limits, controller functions, and calibration before driving.
5. Inspect wiring, air lines, mounts, heat exposure, and system pressure again after the initial operating cycles.