Anderson Composites 2008-2014 Dodge Challenger Front Bumper Canards

The AC-FBC0910DGCH-OE carbon fiber fender for the 2008-2014 Dodge Challenger is precision-engineered from 3K 2×2 twill carbon fiber using a vacuum-infused wet layup, delivering the iconic carbon weave with up to 50% weight savings over the factory steel panel. Fenders are among the most visible body panels on any vehicle, and this replacement delivers up to 50% weight savings over the factory steel unit while maintaining the OEM mounting points and body line accuracy for a true bolt-on installation. Whether the goal is weight reduction, clean carbon aesthetics, or preparation for a wider track build, the AC-FBC0910DGCH-OE executes without compromise.

Key Features

• Material: 3K 2×2 twill carbon fiber, vacuum-infused wet layup.
• Weight savings: up to 50% vs. OEM steel fender.
• Finish: marine-grade gel coat with UV inhibitors, hand-polished to a gloss finish.
• Direct bolt-on using OEM mounting points, no drilling or cutting required.
• Anderson Composites carbon fiber fender (AC-FBC0910DGCH-OE).
• Compatible with OEM fender liner and wheel arch components.

Fitment

Specifications

What’s Included

• Anderson Composites carbon fiber fender (AC-FBC0910DGCH-OE)
• OEM mounting hardware not included, reuses factory bolts and clips

Brand Information

Anderson Composites manufactures application-specific carbon fiber, fiberglass, and composite exterior components for performance vehicles. Construction, finish, mounting, and vehicle compatibility remain manufacturer-part-number specific.

Related Parts

• Anderson Composites Products
• Dodge Challenger Parts
• Performance Fenders
• Fender Flares

Frequently Asked Questions

Does this fender require any drilling or cutting to install?
No. The AC-FBC0910DGCH-OE is precision-molded for exact OEM fitment and uses the existing mounting holes and factory bolt pattern. Minor gap adjustments are normal, but no new holes or structural modifications are required.

Is the OEM fender liner compatible with this carbon fender?
Yes. The inner mounting structure accommodates the factory fender liner and wheel arch trim. If modifications are needed for liner clip locations, minor adjustment with a small drill or file is typically sufficient.

Can this fender be painted?
Yes. The gel coat surface accepts standard automotive paint. Prep with a flexible composite primer, apply basecoat, and finish with 2K clear coat for a factory color match.

What weight savings does this deliver over the factory steel fender?
Anderson Composites carbon fiber construction achieves up to 50% weight savings versus the OEM steel unit. Unsprung front weight directly affects steering response, turn-in, and suspension feel, the improvement is noticeable, especially at track speeds.

Installation Instructions

1. Remove the fender liner to access the inner mounting bolts
2. Disconnect the side marker lamp wiring harness if present
3. Remove all OEM fender mounting bolts, typically at the wheel arch, firewall, and along the hood edge
4. Lift the factory fender away from the vehicle carefully
5. Test-fit the AC-FBC0910DGCH-OE on the mounting points before installing any bolts
6. Start all bolts by hand to allow position adjustment before tightening
7. Set gaps against the hood and door to match OEM spacing, then tighten all bolts
8. Reinstall fender liner, side marker lamp, and any removed trim pieces

WARNING: This product can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and reproductive harm. For more information go to www.P65Warnings.ca.gov.