Anderson Composites 2008-2014 Dodge Challenger Rear Spoiler

The AC-RS0910DGCH-OE rear spoiler for the 2008-2014 Dodge Challenger is built from 3K 2×2 twill carbon fiber using a vacuum-infused wet layup, delivering the iconic carbon weave with up to 50% weight savings over the factory steel panel. This part bolts directly onto the deck lid using the factory mounting points, no drilling, no body modification. The AC-RS0910DGCH-OE pairs naturally with Anderson Composites’ matching trunk lids, diffusers, and aero components to build a fully coordinated carbon exterior with a track-ready character that carries over to every drive.

Key Features

• Material: 3K 2×2 twill carbon fiber, vacuum-infused wet layup.
• Finish: marine-grade gel coat with UV inhibitors, hand-polished to a gloss finish.
• Weight savings: up to 50% vs. OEM factory spoiler.
• Direct OEM bolt-on using existing deck lid mounting points.
• Anderson Composites carbon fiber rear spoiler (AC-RS0910DGCH-OE).
• Precision-molded from the OEM panel for an exact body line match.

Fitment

Specifications

What’s Included

• Anderson Composites carbon fiber rear spoiler (AC-RS0910DGCH-OE)
• Mounting hardware (uses OEM deck lid mounting points)

Brand Information

Anderson Composites manufactures application-specific carbon fiber, fiberglass, and composite exterior components for performance vehicles. Construction, finish, mounting, and vehicle compatibility remain manufacturer-part-number specific.

Related Parts

• Anderson Composites Products
• Dodge Challenger Parts
• Spoilers and Wings
• Exterior Parts

Frequently Asked Questions

Does installation require drilling into the deck lid?
No. This spoiler uses the factory mounting points already on the deck lid. No new holes are required, the install is non-destructive and uses the OEM bolt pattern.

Will this affect the power trunk or factory backup camera?
No. The spoiler is designed around the OEM trunk lid geometry and does not interfere with the factory latch or release. On vehicles with a camera integrated into the spoiler mount area, verify the camera location relative to the new spoiler before ordering.

Can this spoiler be painted to match my vehicle?
Yes. The gel coat surface accepts standard automotive paint. Sand lightly, prime with a flexible composite primer, then apply basecoat and 2K clear coat for a color-matched result.

Does this spoiler pair with the Anderson Composites trunk lid?
Yes. Anderson Composites designs their spoilers to complement their trunk lids with consistent weave patterns and finish levels. Running both creates a seamless coordinated look across the entire rear of the vehicle.

Installation Instructions

1. Mask surrounding paint with painter’s tape to protect the deck lid finish
2. Open the trunk and access the OEM spoiler mounting nuts from the underside of the deck lid
3. Remove the OEM spoiler mounting nuts and lift the spoiler free from the deck lid studs
4. Clean all mounting surfaces to remove adhesive residue and debris
5. Test-fit the AC-RS0910DGCH-OE to confirm alignment and gap before final fastening
6. Set the spoiler onto the mounting studs and thread the nuts to hand-tight
7. Adjust for uniform gap around the perimeter, then torque to factory specification

WARNING: This product can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and reproductive harm. For more information go to www.P65Warnings.ca.gov.