Anderson Composites 2015-2024 Dodge Challenger Taillight Surround

The AC-TLS15DGCH accessory for the 2015-2024 Dodge Challenger is manufactured from 3K 2×2 twill carbon fiber using a vacuum-infused wet layup, delivering the iconic carbon weave with up to 50% weight savings over the factory steel panel. Precision-molded from the OEM panel for an exact body line match, this part delivers up to 50% weight savings over the factory component and installs using existing OEM attachment points with no cutting, drilling, or modification required. Anderson Composites has set the benchmark for carbon fiber exterior components for over a decade, and the AC-TLS15DGCH reflects that heritage in construction, finish, and fitment accuracy.

Key Features

• Material: 3K 2×2 twill carbon fiber, vacuum-infused wet layup.
• Finish: marine-grade gel coat with UV inhibitors, hand-polished to a gloss finish.
• Weight savings: up to 50% vs. OEM panel.
• Direct bolt-on installation using factory mounting points.
• Anderson Composites carbon fiber accessory (AC-TLS15DGCH).
• Precision-molded from OEM part for exact fitment and body line accuracy.

Fitment

Specifications

What’s Included

• Anderson Composites carbon fiber accessory (AC-TLS15DGCH)
• Mounting hardware (uses OEM attachment points)

Brand Information

Anderson Composites manufactures application-specific carbon fiber, fiberglass, and composite exterior components for performance vehicles. Construction, finish, mounting, and vehicle compatibility remain manufacturer-part-number specific.

Related Parts

• Anderson Composites Products
• Dodge Challenger Parts
• Carbon Fiber Parts
• Exterior Parts

Frequently Asked Questions

Does this require drilling or modification to install?
No. Anderson Composites molds every part from the OEM component so the mounting points are factory-exact. The accessory installs using existing attachment locations without permanent body modification.

What construction process does Anderson Composites use?
Anderson Composites uses a vacuum-infused 3K 2×2 twill carbon fiber wet layup. Resin is drawn evenly through the fiber mat under vacuum pressure, producing a consistent resin-to-fiber ratio without voids.

Can this part be painted?
Yes. Lightly sand the gel coat surface, apply a flexible composite primer, and finish with automotive basecoat and 2K clear coat.

Is this compatible with factory hardware?
Yes. Anderson Composites designs every part to work with OEM fasteners, clips, and mounting brackets. No specialty hardware is required for standard installation.

Installation Instructions

1. Mask surrounding paint with tape or moving blankets to protect the existing finish
2. Remove the factory accessory by releasing all OEM fasteners and clips
3. Clean all mounting surfaces to remove adhesive residue and debris
4. Test-fit the AC-TLS15DGCH to confirm alignment before final installation
5. Secure using factory fasteners and any supplemental adhesive appropriate for the part type
6. Inspect all gaps and body line continuity before driving

WARNING: This product can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and reproductive harm. For more information go to www.P65Warnings.ca.gov.