ARB Brushless Twin Motor On-Board 12V Air Compressor Kit

This ARB compressed-air component is the Brushless Twin Motor On-Board 12V Air Compressor Kit. Confirm voltage, duty cycle, pressure and flow requirements, port size, mounting space, wiring, air-line routing, and compatibility with the intended tire or Air Locker system.

Key Features

• Air Flow: 9.18 CFM at 0 PSI, 6.20 CFM at 29 PSI.
• Height: 6.69 inches (170 mm).
• Width: 13.31 inches (338 mm).
• Length: 14.49 inches (368 mm).
• IP67 Water-Resistant Rating: Sealed against dust and water, ensuring reliable performance in extreme conditions.
• IP Rating: IP67 (Water-Resistant and Dustproof).

Fitment

Specifications

What’s Included

One new ARB air compressor system in the exact configuration and quantity identified by this listing. Brackets, wiring, air lines, fittings, switches, fasteners, fitting kits, fluids, covers, and accessories are included only when expressly stated for this exact part.

About ARB

ARB develops vehicle-specific four-wheel-drive equipment, including protection, suspension, Air Lockers, compressed-air systems, racks, recovery equipment, lighting, and touring accessories. Every application, load rating, interface, and included component remains exact-part specific.

Important Disclosures

• California Proposition 65 warning applies. Review the current manufacturer warning before handling or installation.

Related Parts

• Shop all ARB products
• ARB 4L Alloy Air Tank w/ 4 Fittings for High Output Compressors
• ARB Brushless Single Motor On-Board 12V Air Compressor Kit
• ARB Compressor Mdm Portable 12V

Frequently Asked Questions

Will this compressor operate an ARB Air Locker and inflate tires?
Capabilities depend on pressure, flow, duty cycle, tank, manifold, wiring, and the exact compressor model. Size the complete system for every intended function.

What wiring and fuse are required?
Use the voltage, wire gauge, fuse or breaker, relay, switch, and grounding method specified for the exact compressor and installation length.

Where should the compressor be mounted?
Use a protected, ventilated position within the stated orientation and temperature limits, with safe wiring and air-line routing away from heat, water, abrasion, and moving parts.

Installation Instructions

1. Confirm ARB part number CKBLTA12, the complete application, and every required supporting component before beginning work.
2. Mount the component in the specified orientation, then route protected power, grounds, switches, fuses, air lines, fittings, and manifolds away from heat and moving parts.
3. Pressure-test every connection, verify cut-in and cut-out behavior and current draw, and correct all leaks or electrical faults before use.