ARB Hose Reinforced Jic-4 2M 1Pk

This ARB compressed-air component is the Hose Reinforced Jic-4 2M 1Pk. Confirm voltage, duty cycle, pressure and flow requirements, port size, mounting space, wiring, air-line routing, and compatibility with the intended tire or Air Locker system.

Key Features

• Title:ARB – 0740205 – Reinforced Stainless Steel Braided PTFE Hose.

Fitment

Specifications

What’s Included

One new ARB air compressor in the exact configuration and quantity identified by this listing. Brackets, wiring, air lines, fittings, switches, fasteners, fitting kits, fluids, covers, and accessories are included only when expressly stated for this exact part.

About ARB

ARB develops vehicle-specific four-wheel-drive equipment, including protection, suspension, Air Lockers, compressed-air systems, racks, recovery equipment, lighting, and touring accessories. Every application, load rating, interface, and included component remains exact-part specific.

Important Disclosures

• California Proposition 65 warning applies. Review the current manufacturer warning before handling or installation.

Related Parts

• Shop all ARB products
• ARB 90 Elbow Jic4M 1/4NptM 2Pk
• ARB Adapter 1/4Npt M/F/F Tee 2Pk
• ARB Adapter 1/4NptM Jic4M 2Pk

Frequently Asked Questions

Will this compressor operate an ARB Air Locker and inflate tires?
Capabilities depend on pressure, flow, duty cycle, tank, manifold, wiring, and the exact compressor model. Size the complete system for every intended function.

What wiring and fuse are required?
Use the voltage, wire gauge, fuse or breaker, relay, switch, and grounding method specified for the exact compressor and installation length.

Where should the compressor be mounted?
Use a protected, ventilated position within the stated orientation and temperature limits, with safe wiring and air-line routing away from heat, water, abrasion, and moving parts.

Installation Instructions

1. Confirm ARB part number 0740205, the complete application, and every required supporting component before beginning work.
2. Mount the component in the specified orientation, then route protected power, grounds, switches, fuses, air lines, fittings, and manifolds away from heat and moving parts.
3. Pressure-test every connection, verify cut-in and cut-out behavior and current draw, and correct all leaks or electrical faults before use.