ARB Rear Bar Textured Blk Jk Jeep

This ARB vehicle-protection component is the Rear Bar Textured Blk Jk Jeep for 2011 Jeep Wrangler. Confirm body style, trim, chassis and bumper configuration, sensors, cameras, recovery equipment, mounting points, finish, and all stated exclusions.

Key Features

• ARB Rear Bumper.Vehicle Specific.Black.Steel.Dual Jacking Points.Low-Slip Tread Vehicle Specific Design.Development – To ensure we meet your expectations ARB invests heavily in research and development.
• With an air bag equipped vehicle for example it is essential that the vehicle’s crush rate and air bag triggering is not altered when a bull bar is installed.
• What’s more we’re also constantly on the lookout for new ways to improve our business practices from distribution to customer service.
• Designed with the weight of over-sized tires in mind this rear bumper is designed to integrate with a factory fitted or aftermarket Receiver hitch that mounts to the center of the chassis rear cross member.

Fitment

Specifications

What’s Included

One new ARB bumpers – steel in the exact configuration and quantity identified by this listing. Brackets, wiring, air lines, fittings, switches, fasteners, fitting kits, fluids, covers, and accessories are included only when expressly stated for this exact part.

About ARB

ARB develops vehicle-specific four-wheel-drive equipment, including protection, suspension, Air Lockers, compressed-air systems, racks, recovery equipment, lighting, and touring accessories. Every application, load rating, interface, and included component remains exact-part specific.

Important Disclosures

• California Proposition 65 warning applies. Review the current manufacturer warning before handling or installation.

Related Parts

• Shop all ARB products
• ARB Combar Oe Fog W/Crush Cans Txtd Jk 07On8-9.5
• ARB Stubby Bar Textured Jeep Jk
• ARB W/T/Carrier Suit 5650360/370 Jk

Frequently Asked Questions

Will this fit 2011 Jeep Wrangler with factory sensors and cameras?
Compatibility depends on the exact trim, bumper, sensor, camera, radar, recovery, and lighting configuration. Confirm every application note before disassembly.

Is every bull bar or bumper rated as a recovery point?
No. Use only recovery points and towing locations expressly rated for that purpose. A bumper or protection bar does not automatically establish a recovery rating.

Will installation require drilling, trimming, or calibration?
Requirements vary by exact vehicle and component. Review the current ARB instructions and account for sensors, cameras, wiring, bodywork, and driver-assistance calibration.

Installation Instructions

1. Confirm ARB part number 5650360, the complete application, and every required supporting component before beginning work.
2. Protect bodywork and wiring, account for sensors and cameras, and dry-fit every bracket before drilling, trimming, or tightening hardware.
3. Torque all mounts, verify clearance and driver-assistance functions, aim lights if fitted, and recheck hardware after the initial drive.