Autometer 1/8 NPTF 60-210F Degree Replacement Water Temperature Sensor

These replacement temperature sensors are designed specifically for use with AutoMeter high precision low temperature water temperature gauges. Confirm the measurement range, diameter, sender or signal requirements, lighting, electrical system, mounting depth, and included components before ordering.

Key Features

• Construction: Stainless steel probe resists corrosion and vibration in engine bays.
• Temperature Range: 60-210F calibration captures low-temp shifts critical for boosted and race engines.
• Stainless steel body and probe handle coolant antifreeze and oils.

Fitment

Specifications

What’s Included

One new AutoMeter product identified by manufacturer part number 2250. Senders, adapters, fittings, wiring, mounting hardware, gauges, and companion components are included only when expressly stated for this exact part number.

About AutoMeter

AutoMeter develops performance instrumentation, gauge mounting solutions, sensors, data products, battery equipment, and installation components for street, competition, marine, and professional workshop use.

Related AutoMeter Products

• Autometer ES Sensor Temperature 1/8in NPT Male Replacement Short Sweep
• Autometer 0-2000PSI 1/8 Inch NPT Male Brake & Nitrous Pressure Sensor
• Autometer Replacement Sensor for Full Sweep Electric Temperature gauges

Browse the AutoMeter collection for additional gauges, mounts, sensors, and accessories.

Frequently Asked Questions

What signal or sender does AutoMeter gauge 2250 require?
The requirement depends on whether this exact gauge is mechanical, electric, digital, GPS, or vehicle-data based. Use only the sender, tubing, harness, adapter, and signal type specified by AutoMeter.

Will AutoMeter 2250 fit my existing gauge mount?
Confirm the stated gauge diameter, case depth, bezel clearance, rear connection clearance, retaining method, and wiring or tubing path before choosing a mount.

Is calibration required for AutoMeter 2250?
Calibration depends on the measurement and signal source. Follow the current AutoMeter instructions for this exact part and verify the reading against known operating data before relying on it.

What must be tested after wiring AutoMeter 2250?
Verify power, ground, illumination, dimming, signal behavior, sender operation, warning functions, and stable readings through the expected operating range.

Installation Instructions

Follow the current AutoMeter instructions for this exact gauge. Verify the signal or sender, pressure or temperature connection, power, ground, fuse, illumination, mounting depth, tubing or wiring protection, calibration, leak checks, and stable readings before driving.