Autometer Replacement 100psi Oil Pressure Sender

These replacement pressure sensors and included 1/4″ adapter bushings are designed specifically for use with AutoMeter short sweep electric air core gauges. Confirm the measurement range, diameter, sender or signal requirements, lighting, electrical system, mounting depth, and included components before ordering.

Key Features

• Title:SENSOR, OIL PRESSURE, 0-100 PSI, 1/8 in. NPT MALE, FOR SHORT SWEEP ELEC.

Fitment

Specifications

What’s Included

One new AutoMeter product identified by manufacturer part number 2242. Senders, adapters, fittings, wiring, mounting hardware, gauges, and companion components are included only when expressly stated for this exact part number.

About AutoMeter

AutoMeter develops performance instrumentation, gauge mounting solutions, sensors, data products, battery equipment, and installation components for street, competition, marine, and professional workshop use.

Related AutoMeter Products

• Autometer Replacement Sender for 100psi Oil and Fuel Pressure Full Sweep
• Auto Meter 2-1/16in 100PSI Electronic Oil Pressure Old Tyme White Gauge
• Autometer Accessories 0-100PSI 1/8in. NPT Male Oil Pressure Sensor (For Short Sweep Elec.)

Browse the AutoMeter collection for additional gauges, mounts, sensors, and accessories.

Frequently Asked Questions

What signal or sender does AutoMeter gauge 2242 require?
The requirement depends on whether this exact gauge is mechanical, electric, digital, GPS, or vehicle-data based. Use only the sender, tubing, harness, adapter, and signal type specified by AutoMeter.

Will AutoMeter 2242 fit my existing gauge mount?
Confirm the stated gauge diameter, case depth, bezel clearance, rear connection clearance, retaining method, and wiring or tubing path before choosing a mount.

Is calibration required for AutoMeter 2242?
Calibration depends on the measurement and signal source. Follow the current AutoMeter instructions for this exact part and verify the reading against known operating data before relying on it.

What must be tested after wiring AutoMeter 2242?
Verify power, ground, illumination, dimming, signal behavior, sender operation, warning functions, and stable readings through the expected operating range.

Installation Instructions

Follow the current AutoMeter instructions for this exact gauge. Verify the signal or sender, pressure or temperature connection, power, ground, fuse, illumination, mounting depth, tubing or wiring protection, calibration, leak checks, and stable readings before driving.