Bilstein B4 Rear Shock for Volvo 850, C70, S70 and V70

Rear Shock Control for Volvo 850 / C70 / S70 / V70

Bilstein 19-029450 is a B4 OE Replacement rear shock for maintaining the original ride character. Match the exact applications and suspension notes below before ordering this individual damper.

Key Features

• Twintube construction for maintaining the original ride character.
• Black-painted body with stem upper mount and eye 14.5mm lower mount.
• Application-specific damping for the listed vehicle configurations.
• 19-029450 is sold as one individual rear shock.

Fitment

For vehicles without self-leveling suspension only.

Use the verified application rows for 19-029450; a matching model name alone does not establish compatibility.

Specifications

What’s Included

• One Bilstein 19-029450 rear shock.
• Protective boot listed by Bilstein as Black Straight.

A second shock and replacement coil springs are not supplied. Inspect the original mounts and related suspension service parts before installation.

About Bilstein

Bilstein develops dampers for specific vehicles and suspension configurations. The B4 OE Replacement range focuses on maintaining the original ride character. This product carries the manufacturer’s limited lifetime warranty, subject to its terms.

Related Parts

• Bilstein B6 rear shock for Volvo 850 An alternative performance damper for its own verified applications. Check the suspension configuration before choosing a replacement.

FAQ

What is the 19-029450?

It is an individual Bilstein B4 OE Replacement rear shock for the exact vehicle and suspension applications listed above.

Is this a pair or a complete suspension kit?

No. The listing supplies one individual rear shock; other suspension parts are separate.

Which suspension configuration does it require?

For vehicles without self-leveling suspension only.

Is a new coil spring included?

No. Select or retain the correct spring for the verified vehicle and damper application.

Is a protective boot included?

Yes. The manufacturer specifies a black straight protective boot for this shock.

What is the internal design?

Bilstein specifies a twintube design with application-specific damping.

Will it fit every trim of the vehicles in the title?

No. Match the exact year, model, submodel and suspension notes in the fitment table before ordering.

Who should install this part?

A qualified suspension specialist with the appropriate lifting and service tools should perform installation. The vehicle and suspension must be properly supported during shock replacement.

Installation Instructions

1. Verify the exact application and suspension restrictions, then review the official Bilstein installation instructions.
2. Have a qualified suspension specialist support the vehicle and remove the original rear shock using the vehicle service procedure.
3. Compare the original and replacement mounting points, inspect the mounting hardware and protective components, and install the replacement shock according to the manufacturer procedure.
4. Tighten fasteners according to the vehicle and Bilstein service instructions, then check clearances, alignment where applicable and suspension operation.

California Proposition 65 Warning

WARNING: Cancer & Reproductive Harm – www.P65Warnings.ca.gov