Bilstein B6 4600 Front Shock for 2007-2014 GM Trucks and SUVs

Restore Controlled Suspension Response at the Correct Corner

Consistent damping helps keep the tire settled over rough pavement and during weight transfer. Bilstein 24-317825 is built for 2007-2014 applications from Chevrolet and GMC shown in the Fitment table. Key details are Bilstein B6 4600 and front.

Key Features

• Bilstein 24-317825: Bilstein B6 4600
• front
• monotube
• 12.95 in collapsed, 18.08 in extended
• bar-pin/stem
• yellow
• stock-height
• UPC 651860921365

Fitment

Use Bilstein 24-317825 only for the applications below. Confirm every listed qualifier and exclusion.

Specifications

What’s Included

• One front shock absorber for Bilstein 24-317825
• Spring seat
• Not included: Boot

About Bilstein

Bilstein builds monotube and twin-tube dampers for OE replacement, street performance, and off-road use, with each series tuned for a defined vehicle or dimensional application.

Related Parts

• Check application-matched mounts, boots, bump stops, springs, and opposite-side dampers separately as the installation requires.

FAQ

What is the 24-317825?

It is a Bilstein suspension shock absorber for 2007-2014 applications from Chevrolet and GMC shown in the Fitment table, built around Bilstein B6 4600.

What is the main benefit of this part?

Bilstein B6 4600; front.

Which applications does it fit?

It is intended for 2007-2014 applications from Chevrolet and GMC shown in the Fitment table. Use the Fitment table and every listed qualifier before ordering.

What comes with this product?

One front shock absorber; Spring seat.

What construction details should I know?

Suspension shock absorber.

What should be checked before installation?

Compare the old and new parts, confirm position and orientation, and verify all application notes, clearances, fasteners, and required companion parts.

How should this part be installed?

Bolt the shock into the stock-height application. Follow all torque, alignment, bleeding, calibration, or break-in procedures that apply.

What warranty applies?

Limited lifetime warranty.

Installation Instructions

1. Bolt the shock into the stock-height application.
2. Confirm the exact part number, application, included components, and all required tools before disassembly.
3. Inspect mounting points, mating parts, clearances, wiring, fluids, and fasteners before installation.
4. Install according to the current manufacturer instructions and all specified torque, alignment, or calibration procedures.

California Proposition 65 Warning: Store/retailer evidence indicates a Proposition 65 warning is used; manufacturer product page links safety data but does not name a chemical. Preserve a general warning only.