Bilstein B8 5112 Front Leveling Kit for 2013-2026 Ram 3500 4WD

Level Your Ram 3500 With a Matched Bilstein Front System

Bilstein 46-241634 is a B8 5112 front suspension leveling kit engineered for 2013-2026 Ram 3500 4WD trucks. The matched pair of 46mm monotube dampers and coil springs provides approximately 2 inches of front lift while retaining application-specific damping for road, towing, and off-road use.

Key Features

• Complete front system with two B8 5100 monotube dampers and two matched coil springs
• Approximately 2-inch front lift for added ground clearance and a level stance
• Velocity-sensitive digressive valving reacts to changing road and trail inputs
• Direct-fit mounting at factory locations with no damper modification
• Zinc-plated dampers, black springs, and black bellows boots
• Bilstein 46-241634 is non-adjustable; an adjustable track bar is recommended
• Use the exact 46-241634 configuration; related Bilstein part numbers can have different dimensions, sides, or fitment

Fitment

Specifications

What’s Included

• Two front B8 5100 shock absorbers
• Two matched front coil springs
• Application-specific mounting hardware as supplied by Bilstein

About Bilstein

Bilstein develops OE and aftermarket monotube suspension systems using application-specific testing, gas-pressure technology, and controlled manufacturing standards. 46-241634 is engineered around the application and dimensions listed above.

Related Parts

• No internal recommendation is linked because a compatible companion part must be verified for the exact vehicle, suspension option, side, and ride height before purchase.

FAQ

What is the 46-241634?

It is the Bilstein B8 5112 suspension lift kits described on this page, supplied in the verified configuration and quantity shown above.

Is this sold as a pair or individually?

Two front B8 5100 shock absorbers; Two matched front coil springs; Application-specific mounting hardware as supplied by Bilstein. The included-components section controls the package quantity.

Is the damping adjustable?

Non-adjustable

Will this fit every trim of the listed vehicle?

No. Confirm the year, model, suspension option, drivetrain, engine, ride height, and position notes before ordering.

Does installation require an alignment?

An alignment is recommended whenever suspension geometry or ride height is changed, and after strut or spring service when specified by the vehicle manufacturer.

Can factory hardware be reused?

Reuse hardware only when the Bilstein and vehicle service instructions allow it and the hardware passes inspection. Replace one-time-use or damaged fasteners.

What warranty applies?

Bilstein limited lifetime warranty

What should be checked before installation?

Compare the part number, side, mount style, suspension option, ride height, and included components with the vehicle and current Bilstein application data.

Installation Instructions

1. Confirm the vehicle, suspension option, ride height, side, and mount configuration before installing Bilstein 46-241634.
2. Support the vehicle safely and follow the factory service procedure for spring or damper removal.
3. Inspect mounts, bushings, fasteners, and adjacent suspension components; replace worn or one-time-use hardware as required.
4. Install the component in the specified orientation and route any reservoir hose away from heat, abrasion, and moving parts.
5. Torque all fasteners at the suspension position specified by the vehicle and Bilstein instructions.
6. Set the vehicle on the ground, verify clearance and ride height, road-test carefully, and perform an alignment when required.

California Proposition 65: Cancer and reproductive harm. See www.P65Warnings.ca.gov.