Bilstein B8 5162 Front Leveling Kit for 2014-2026 Ram 2500

Keep Damping Consistent When the Road Gets Rough

Remote-reservoir capacity helps manage heat and maintain suspension control during sustained use. Bilstein 46-263889 is built for 2014-2022 Ram 2500 applications shown in the Fitment table. Key details are Bilstein B8 5162 and two B8 5160 monotube reservoir shocks plus two matched 472 lb/in springs.

Key Features

• Bilstein 46-263889: Bilstein B8 5162
• two B8 5160 monotube reservoir shocks plus two matched 472 lb/in springs
• zinc/black
• 46 mm piston
• Ram 2500 2014-2026; front; verify exact drivetrain, cab and axle configuration

Fitment

Use Bilstein 46-263889 only for the applications below. Confirm every listed qualifier and exclusion.

Specifications

What’s Included

• Two front B8 5160 remote-reservoir shocks for Bilstein 46-263889
• Two matched 472 lb/in coil springs
• Not included: Rear shocks

About Bilstein

Bilstein builds monotube and twin-tube dampers for OE replacement, street performance, and off-road use, with each series tuned for a defined vehicle or dimensional application.

Related Parts

• Check every application-matched fastener, seal, mounting part, and companion component required for the complete installation.

FAQ

What is the 46-263889?

It is a Bilstein front suspension leveling kit for 2014-2022 Ram 2500 applications shown in the Fitment table, built around Bilstein B8 5162.

What is the main benefit of this part?

Bilstein B8 5162; two B8 5160 monotube reservoir shocks plus two matched 472 lb/in springs.

Which applications does it fit?

It is intended for 2014-2022 Ram 2500 applications shown in the Fitment table. Use the Fitment table and every listed qualifier before ordering.

What comes with this product?

Two front B8 5160 remote-reservoir shocks; Two matched 472 lb/in coil springs.

What construction details should I know?

Front suspension leveling kit.

What should be checked before installation?

Compare the old and new parts, confirm position and orientation, and verify all application notes, clearances, fasteners, and required companion parts.

How should this part be installed?

Bolt the kit into the factory front suspension locations. Follow all torque, alignment, bleeding, calibration, or break-in procedures that apply.

What warranty applies?

Limited 2-year warranty.

Installation Instructions

1. Bolt the kit into the factory front suspension locations.
2. Confirm the exact part number, application, included components, and all required tools before disassembly.
3. Inspect mounting points, mating parts, clearances, wiring, fluids, and fasteners before installation.
4. Install according to the current manufacturer instructions and all specified torque, alignment, or calibration procedures.

California Proposition 65 Warning: Store/retailer evidence indicates a Proposition 65 warning is used; manufacturer product page links safety data but does not name a chemical. Preserve a general warning only.