Bilstein B8 Performance Plus Rear Shock for Audi and Volkswagen

Rear Shock Control for Audi / Volkswagen

Bilstein 24-178006 is a B8 Performance Plus rear shock for pairing with compatible lowering springs. Match the exact applications and suspension notes below before ordering this individual damper.

Key Features

• Monotube construction for pairing with compatible lowering springs.
• Yellow-painted body with stem upper mount and eye 14.2mm lower mount.
• Application-specific damping for the listed vehicle configurations.
• 24-178006 is sold as one individual rear shock.

Fitment

Designed to be paired with compatible aftermarket lowering springs. Check all mounting-bolt and electronic-suspension notes below.

Use the verified application rows for 24-178006; a matching model name alone does not establish compatibility.

Specifications

What’s Included

• One Bilstein 24-178006 rear shock.

A second shock and replacement coil springs are not supplied. Inspect the original mounts and related suspension service parts before installation.

About Bilstein

Bilstein develops dampers for specific vehicles and suspension configurations. The B8 Performance Plus range focuses on pairing with compatible lowering springs. This product carries the manufacturer’s limited lifetime warranty, subject to its terms.

Related Parts

• Bilstein B6 rear shock for Audi A3 An alternative damper range for stock-height use. This B8 listing is intended for compatible aftermarket lowering springs; do not treat the two ranges as interchangeable.

FAQ

What is the 24-178006?

It is an individual Bilstein B8 Performance Plus rear shock for the exact vehicle and suspension applications listed above.

Is this a pair or a complete suspension kit?

No. The listing supplies one individual rear shock; other suspension parts are separate.

Which suspension configuration does it require?

Designed to be paired with compatible aftermarket lowering springs. Check all mounting-bolt and electronic-suspension notes below.

Is a new coil spring included?

No. Select or retain the correct spring for the verified vehicle and damper application.

Is a protective boot included?

No. The manufacturer lists no included boot; the installer must inspect the applicable original protective components.

What is the internal design?

Bilstein specifies a monotube design with application-specific damping.

Will it fit every trim of the vehicles in the title?

No. Match the exact year, model, submodel and suspension notes in the fitment table before ordering.

Who should install this part?

A qualified suspension specialist with the appropriate lifting and service tools should perform installation. The vehicle and suspension must be properly supported during shock replacement.

Installation Instructions

1. Verify the exact application and suspension restrictions, then review the official Bilstein installation instructions.
2. Have a qualified suspension specialist support the vehicle and remove the original rear shock using the vehicle service procedure.
3. Compare the original and replacement mounting points, inspect the mounting hardware and protective components, and install the replacement shock according to the manufacturer procedure.
4. Tighten fasteners according to the vehicle and Bilstein service instructions, then check clearances, alignment where applicable and suspension operation.