Borla 11-14 Dodge Challenger 3.6L AT/MT RWD 2Dr Single Split Rear Exit Rectangle Tip Catback Exhaust

This Borla cat-back exhaust system is built for the verified 2011 Dodge Challenger SE application listed below. Select it by exact manufacturer part number 140482 and confirm the full engine, drivetrain, body, wheelbase, factory-exhaust, and Borla application notes before ordering.

Key Features

• T-304 Stainless Steel: Premium material throughout for corrosion resistance, durability, and a lifetime of performance.
• System weight: 38 lbs for balanced performance without added stress.
• X-Pipe Technology: Increases scavenging efficiency for better engine breathing, power, and a deeper exhaust note.
• Direct bolt-on replacement using factory mounting points; no cutting or welding required.
• Bolt-on design fits AT/MT; remove stock cat-back from mid-pipes rearward.
• Decades as pioneer in stainless steel exhaust for classics to modern performance cars.

Fitment

Specifications

What’s Included

One new Borla product identified by manufacturer part number 140482. Clamps, hangers, gaskets, tips, pipes, tools, and companion parts are included only when expressly listed for this exact part number.

About Borla

Borla develops stainless-steel exhaust systems, mufflers, tips, pipes, and related components for vehicle-specific and universal performance applications. Product selection remains exact-application and exact-part-number specific.

Related Borla Products

• Borla 09-14 Dodge Challenger R/T 5.7L RWD 2Dr. 2.5in. ATAK CB Exhaust – Dual Split Rear Exit
• Borla 09-14 Dodge Challenger R/T 5.7L RWD 2Dr. Dual Rctgl. Angle S-Type CB Exhaust – Rear Split Exit
• Borla 14-15 Camaro 3.6L V6 Single Split Rear Exit Touring Catback Exhaust

Browse the Borla collection for related exhaust systems and components.

Frequently Asked Questions

Will this Borla part fit my 2011 Dodge Challenger SE?
That application is listed, but confirm the engine, drivetrain, body or cab style, wheelbase, factory exhaust layout, tip opening, and every Borla application note before ordering.

Will this change require an engine tune?
A cat-back, axle-back, tip, muffler, or post-catalyst component usually does not require tuning, but confirm the exact application, emissions configuration, oxygen-sensor locations, and local requirements before installation.

What should I inspect before installation?
Check the shipping carton and components against the exact part number, then inspect clamps, hangers, gaskets, mating flanges, clearances, tip alignment, and required reused factory hardware before removing the original exhaust.

Installation Instructions

Follow the current Borla instructions and vehicle service information for this exact part number. Let the exhaust cool, support the vehicle safely, compare all parts before removal, protect sensors and wiring, use the specified clamps and torque values, align all joints and tips without preload, confirm body and suspension clearance, check for leaks, and retorque after the first heat cycles. Professional installation is recommended.