Borla 2010 Camaro 3.6L V6(except 2013RS) SS Exhaust (rear section only)

This Borla axle-back exhaust system is built for the verified 2010-2013 Chevrolet Camaro LS application listed below. Select it by exact manufacturer part number 11776 and confirm the full engine, drivetrain, body, wheelbase, factory-exhaust, and Borla application notes before ordering.

Key Features

• 2.25-inch Tubing Diameter: Optimizes scavenging for better throttle response, efficiency, and up to 43 lbs lighter than stock systems.
• T-304 Stainless Steel Construction: Ensures durability and corrosion resistance with all-welded assembly for long-lasting performance.
• Straight-Through Muffler Design: Improves exhaust flow for noticeable horsepower and torque increases plus a refined motorsport tone.
• Polished 3.5-inch T-304 Stainless Tips: Single split rear exit style adds aggressive styling that complements the Camaro’s lines.
• Direct bolt-on replacement; no cutting or welding required for most installations.
• Bolt-on design uses factory hangers and mounts for 1-2 hour install time.

Fitment

Specifications

What’s Included

One new Borla product identified by manufacturer part number 11776. Clamps, hangers, gaskets, tips, pipes, tools, and companion parts are included only when expressly listed for this exact part number.

About Borla

Borla develops stainless-steel exhaust systems, mufflers, tips, pipes, and related components for vehicle-specific and universal performance applications. Product selection remains exact-application and exact-part-number specific.

Related Borla Products

• Borla 14-15 Chevy Camaro 3.6L V6 RWD Single Split Rr Exit Touring Exhaust (rear section only)
• Borla 11-14 CTS Coupe V6 3.6L AT RWD/AWD Dual Ctr Rear Exit Touring Exhaust (REAR SECTION ONLY)
• Borla 05-09 Mustang 4.0L V6 AT/MT RWD 2dr SS Exhaust (rear section only)

Browse the Borla collection for related exhaust systems and components.

Frequently Asked Questions

Will this Borla part fit my 2010-2013 Chevrolet Camaro LS?
That application is listed, but confirm the engine, drivetrain, body or cab style, wheelbase, factory exhaust layout, tip opening, and every Borla application note before ordering.

Will this change require an engine tune?
A cat-back, axle-back, tip, muffler, or post-catalyst component usually does not require tuning, but confirm the exact application, emissions configuration, oxygen-sensor locations, and local requirements before installation.

What should I inspect before installation?
Check the shipping carton and components against the exact part number, then inspect clamps, hangers, gaskets, mating flanges, clearances, tip alignment, and required reused factory hardware before removing the original exhaust.

Installation Instructions

Follow the current Borla instructions and vehicle service information for this exact part number. Let the exhaust cool, support the vehicle safely, compare all parts before removal, protect sensors and wiring, use the specified clamps and torque values, align all joints and tips without preload, confirm body and suspension clearance, check for leaks, and retorque after the first heat cycles. Professional installation is recommended.