Borla 2018-2022 Ford Mustang GT Cat-Back Exhaust System Touring- Rolled Polished Tips

This Borla cat-back exhaust system is built for the verified 2018-2020 Ford Mustang GT application listed below. Select it by exact manufacturer part number 1014045 and confirm the full engine, drivetrain, body, wheelbase, factory-exhaust, and Borla application notes before ordering.

Key Features

• ECE Approved (ECE-R59): Complies with Economic Commission for Europe regulations for motor vehicles, ensuring legal road use in certified regions.
• Internal H-Pipe in Front Resonator: Balances exhaust pulses for smoother flow, enhanced performance, and refined tone.
• T-304 Stainless Steel Construction: Premium austenitic material with mandrel bends for maximum flow, durability, and corrosion resistance.
• Features 2.5-inch piping, split rear exit, 4-inch round rolled polished T-304 stainless steel tips (9.5 inches long).
• Active Exhaust Valves: Allows driver control over sound and performance levels for versatile driving.
• Designed as direct bolt-on replacement; no cutting or welding required.

Fitment

Specifications

What’s Included

One new Borla product identified by manufacturer part number 1014045. Clamps, hangers, gaskets, tips, pipes, tools, and companion parts are included only when expressly listed for this exact part number.

About Borla

Borla develops stainless-steel exhaust systems, mufflers, tips, pipes, and related components for vehicle-specific and universal performance applications. Product selection remains exact-application and exact-part-number specific.

Related Borla Products

• Borla 2018 Ford Mustang GT 5.0L AT/MT (w/o Valves) ATAK 3in Cat-Back Exhaust w/Polished Tips
• Borla 2018 Ford Mustang GT 5.0L AT/MT (w/o Valves) S-Type 3in Cat-Back Exhaust w/Polished Tips
• Borla 2018 Ford Mustang GT 5.0L AT/MT (w/o Valves) ATAK 3in Cat-Back Exhaust w/Carbon Fiber Tips

Browse the Borla collection for related exhaust systems and components.

Frequently Asked Questions

Will this Borla part fit my 2018-2020 Ford Mustang GT?
That application is listed, but confirm the engine, drivetrain, body or cab style, wheelbase, factory exhaust layout, tip opening, and every Borla application note before ordering.

Will this change require an engine tune?
A cat-back, axle-back, tip, muffler, or post-catalyst component usually does not require tuning, but confirm the exact application, emissions configuration, oxygen-sensor locations, and local requirements before installation.

What should I inspect before installation?
Check the shipping carton and components against the exact part number, then inspect clamps, hangers, gaskets, mating flanges, clearances, tip alignment, and required reused factory hardware before removing the original exhaust.

Installation Instructions

Follow the current Borla instructions and vehicle service information for this exact part number. Let the exhaust cool, support the vehicle safely, compare all parts before removal, protect sensors and wiring, use the specified clamps and torque values, align all joints and tips without preload, confirm body and suspension clearance, check for leaks, and retorque after the first heat cycles. Professional installation is recommended.