COMP Cams Cam Phaser Kit GM L-92

The COMP Cams Cam Phaser Kit GM L-92 is intended for the verified vehicle applications listed below. Match manufacturer part number 5456, exact engine, cylinder head, valvetrain, cam specifications, supporting components, clearances, and every product note before ordering.

Key Features

• Engine oil is pressure fed to the cam phasers through a series of passageways in the cylinder heads and camshafts.
• The engine computers control solenoids that adjust this oil flow into and out of the phaser’s control chambers, giving the ability to retard the cams up to 60 crank degrees.
• Cam phasers are specially designed, computer-controlled cam gears that automatically optimize camshaft timing based on the current engine rpm.

Fitment

Specifications

What’s Included

One new COMP Cams product in the exact configuration and quantity identified by manufacturer part number 5456. Springs, retainers, locks, pushrods, lifters, rockers, timing components, fasteners, lubricants, tools, and calibration are included only when expressly stated for this exact part number.

About COMP Cams

COMP Cams develops camshafts, valvetrain components, timing products, and engine-building tools for performance applications. Correct selection remains exact-engine, exact-valvetrain, exact-interface, and exact-part-number specific.

Related COMP Cams Products

• COMP Cams Cam Phaser Kit 07-08 GM L92 And Gen 5 LT1
• COMP Cams Cam Phaser Kit Ford 3V Limiter
• COMP Cams Phaser Limiter Kit Ford 5.0L

Browse the COMP Cams collection for related camshafts, springs, retainers, lifters, rockers, timing components, and engine tools.

Frequently Asked Questions

Will this COMP Cams product fit my 2007 Cadillac CTS V?
That application is listed, but confirm the exact engine family, valvetrain, cylinder head, cam specifications, supporting parts, and manufacturer part number.

Are valve springs or other supporting parts required?
Requirements depend on the exact camshaft and engine combination. Verify springs, retainers, locks, pushrods, lifters, rockers, timing components, clearances, and calibration before assembly.

Does installation require engine measurements?
Yes for most internal valvetrain work. A qualified builder should verify piston-to-valve clearance, spring pressure and travel, coil bind, retainer clearance, geometry, lash or preload, and cam timing.

Installation Instructions

Follow the current COMP Cams and engine-manufacturer instructions for this exact part number. Verify clearances, spring pressure and travel, geometry, lash or preload, fasteners, lubrication, cam timing, break-in, and calibration requirements before assembly. Inspect and test the completed installation before full-load operation.