COMP Cams Camshaft Set F4.6S XE270AH-13

The COMP Cams Camshaft Set F4.6S XE270AH-13 is intended for the verified vehicle applications listed below. Match manufacturer part number 102600, exact engine, cylinder head, valvetrain, cam specifications, supporting components, clearances, and every product note before ordering.

Key Features

• Noticeable idle.; 270/274 Advertised Duration, 234/238 Duration.050″,.550″/.550″ Lift, 113 Lobe Separation; Requires cam gear set part #10246SET; Requires part #26113-16 valve springs and either 792-16 steel retainers or 791-16 titanium retainers; Part #26125-16 high load valve springs also available.
• Intake, exhaust and custom tuning required.

Fitment

Specifications

What’s Included

One new COMP Cams product in the exact configuration and quantity identified by manufacturer part number 102600. Springs, retainers, locks, pushrods, lifters, rockers, timing components, fasteners, lubricants, tools, and calibration are included only when expressly stated for this exact part number.

About COMP Cams

COMP Cams develops camshafts, valvetrain components, timing products, and engine-building tools for performance applications. Correct selection remains exact-engine, exact-valvetrain, exact-interface, and exact-part-number specific.

Related COMP Cams Products

• COMP Cams Camshaft Set F4.6S XE262Ah-13
• COMP Cams Camshaft Set F4.6S XE278Ah-13
• COMP Cams Camshaft Set F4.6S XE268H-14

Browse the COMP Cams collection for related camshafts, springs, retainers, lifters, rockers, timing components, and engine tools.

Frequently Asked Questions

Will this COMP Cams product fit my 1992-2003 Ford Crown Victoria S?
That application is listed, but confirm the exact engine family, valvetrain, cylinder head, cam specifications, supporting parts, and manufacturer part number.

Are valve springs or other supporting parts required?
Requirements depend on the exact camshaft and engine combination. Verify springs, retainers, locks, pushrods, lifters, rockers, timing components, clearances, and calibration before assembly.

Does installation require engine measurements?
Yes for most internal valvetrain work. A qualified builder should verify piston-to-valve clearance, spring pressure and travel, coil bind, retainer clearance, geometry, lash or preload, and cam timing.

Installation Instructions

Follow the current COMP Cams and engine-manufacturer instructions for this exact part number. Verify clearances, spring pressure and travel, geometry, lash or preload, fasteners, lubrication, cam timing, break-in, and calibration requirements before assembly. Inspect and test the completed installation before full-load operation.