COMP Cams Dodge Hemi (Non MDS) Lifter Kit w/ 4 Yokes

The COMP Cams Dodge Hemi (Non MDS) Lifter Kit w/ 4 Yokes is intended for the verified vehicle applications listed below. Match manufacturer part number 856Y-16, exact engine, cylinder head, valvetrain, cam specifications, supporting components, clearances, and every product note before ordering.

Key Features

• An ideal replacement for factory units, this drop-in lifter is designed to protect against roller bearing wear and lifter body breakage, its ideal for any stock, high performance or racing application.
• COMP lifter yokes perfectly align the lifters and are manufactured from a premium material to meet all factory/OEM requirements.
• Designed as a major upgrade over the commonly sourced Dodge Hellcat lifters, this unique design enhances oil retention around the axle and bearing, helping to reduce wear and increase durability in all applications, stock to high performance.

Fitment

Specifications

What’s Included

One new COMP Cams product in the exact configuration and quantity identified by manufacturer part number 856Y-16. Springs, retainers, locks, pushrods, lifters, rockers, timing components, fasteners, lubricants, tools, and calibration are included only when expressly stated for this exact part number.

About COMP Cams

COMP Cams develops camshafts, valvetrain components, timing products, and engine-building tools for performance applications. Correct selection remains exact-engine, exact-valvetrain, exact-interface, and exact-part-number specific.

Related COMP Cams Products

• COMP Cams 96-04 Ford Modular 4.6L-5.4L SOC Performance Lash Adjusters – Set of 16
• COMP Cams Gen IV 5.3L GM LS DOD Premium Kit
• COMP Cams 09-18 Dodge 5.7L/6.2/6.4 HEMI .600in Lift Beehive Spring Kit w/ Steel Retainers

Browse the COMP Cams collection for related camshafts, springs, retainers, lifters, rockers, timing components, and engine tools.

Frequently Asked Questions

Will this COMP Cams product fit my 2003-2010 Dodge Ram 2500 ST?
That application is listed, but confirm the exact engine family, valvetrain, cylinder head, cam specifications, supporting parts, and manufacturer part number.

Are valve springs or other supporting parts required?
Requirements depend on the exact camshaft and engine combination. Verify springs, retainers, locks, pushrods, lifters, rockers, timing components, clearances, and calibration before assembly.

Does installation require engine measurements?
Yes for most internal valvetrain work. A qualified builder should verify piston-to-valve clearance, spring pressure and travel, coil bind, retainer clearance, geometry, lash or preload, and cam timing.

Installation Instructions

Follow the current COMP Cams and engine-manufacturer instructions for this exact part number. Verify clearances, spring pressure and travel, geometry, lash or preload, fasteners, lubrication, cam timing, break-in, and calibration requirements before assembly. Inspect and test the completed installation before full-load operation.